Filling and removing false nails with the electric file

Today, we will talk about how to properly maintain your nails with the electric file and perform filling or removal of a pose of nails.

Maintenance is essential!

You can proceed to the filling which is recommended every 2 or 3 weeks, in order to replace the stress point in the right place. Now, with a sanding band or the same cylinder used for the raised parts, gradually thin the covering towards the cuticles, taking care not to dig into the natural nail plate. If necessary, you can reduce the length with a medium-grit sanding belt. Subsequently, reduce the thickness of the covering by half in order to be able to reapply the product corresponding to the covering. Using a diamond cylinder, tilt the cutting end and follow the pencil line. Again remove the thickness on the tip following the new curve of the nail. Remove any dust and you can proceed to filling.

Professional Portable Electric Nail Drill 2,000~30,000 RPM, Low Noise, Low Heat and Low Vibration
Portable Electric Nail Drill 2,000~30,000 RPM, Low Noise, Low Heat and Low Vibration
$109.90

Removal with a file is healthier.

To completely remove the cover, trim the nail to the desired length. Set the electric file to medium speed and sand using a medium sanding cylinder or a diamond cylinder. It is best to leave a thin layer of product so as not to affect the natural nail. Finish the nail shape with a traditional file, wash your hands and moisturize the cuticles with an oil.

We hope you liked this article and that it will inspire you for future. In addition to these, I advise you to invest in a complete manicure set to care for your feet in daily life.

Read also: 3D nails: how to make 3D flowers?

Source:

Leave a Reply